B&B Electronics Parallel Printer Card PIOC Manuel d'utilisateur télécharger pdf (Page 7)

Remember to put the alligator clip insulators on the wires before soldering the alligator

clips, and make sure they’re far enough away from the solder joint so that they don’t

overheat and melt.

Powering up the T35-GFX

The 14 gage 4 foot long pair of leads on the left side of the T35-GFX are to be connected

to the DC power supply. The other leads are used to make connections to your pack or

motor.

Avoid using the switch on an outlet strip or the line cord plug on the AC side of your

power supply as a means control power to the T35-GFX. Instead, always make the final

power connection to the T35-GFX AT THE DC INPUT WIRE on the power cable of the

T35-GFX.

After terminating the lead wires, connect the T35-GFX power leads to a 12V-16V DC

power supply. Obviously, the red lead goes to the positive terminal; the black lead to the

negative terminal of the supply. This DC supply should be capable of 20 amps if you

want to utilize the full motor run capacity and 12 amps to realize the full charging

capacity of the T35-GFX. See “Power Supply Requirements,” below, for more details.

Getting Familiar with the T35-GFX Menu System

Like many digital electronic devices, the T35-GFX has an LCD display that

communicates the status of the T35-GFX to the user. By this means, the T35-GFX menu

system is displayed. Below is a “menu tree” showing the navigation pattern for the T35-

GFX menu.

1 2 3 4 5 6 7 8 9 10 11 12 ... 61 62

Pas de commentaire

B&B Electronics Parallel Printer Card PIOC Manuel d'utilisateur Page 7