B&B Electronics Parallel Printer Card PIOC Manuel d'utilisateur télécharger pdf (Page 6)

• Specifications: This section contains a concise technical summary of the T35-

GFX capabilities and requirements data.

• When it doesn’t work: In this section you learn how to tell if your T35-GFX is

broken, and what to do about it. Also, look here for information about how to get

your T35-GFX upgraded, calibrated, etc.

Quick Start: A Starting Line View of the T35-GFX

This section of the manual will get you up and running fast.

Prepping the T35-GFX for use

If your T35-GFX is new out of the box, you will need to configure the power and output

lead wires. CEI supplies heavy duty alligator clips for these lead wires; they must be

soldered to obtain a good connection. Alternately, you may choose to install some other

type of connector, such as a Dean’s® connector for the power connections.

When soldering, be sure to heat the conductors enough so that you get a nice shiny solder

joint. Use enough solder to fully wet the conductors, but not so much that it forms a big

ball, or glob.

Good solder joints are shiny, not dull. Dull solder joints are usually referred to as “cold”

solder joints. The usual cause is not heating the conductors to be soldered sufficiently

before applying the solder.

Figure 1. Soldering an alligator clip.

1 2 3 4 5 6 7 8 9 10 11 ... 61 62

Pas de commentaire

B&B Electronics Parallel Printer Card PIOC Manuel d'utilisateur Page 6